Search results

I have an Oehler coming this week, but I pretty sure it's right.

Yes to all that...

Working with load data and trying to understand why predictions are not close to actual. I'm loading this as pictured but actual velocities are almost 200 fps faster than quickload. 62.5 gr H1000 3246 fps avg 16 ES 8 SD What am I missing here? Cartridge : 6.5 mm RSAUM Bullet : .264, 123...

I believe 2.025 is the trim length most used...

I'll take it for $300.00 Shipped.

Seems to be near Retumbo burn rates

It's not in the powder profiles yet...

Hornady brass, ? # times fired but primers were tight when loaded. 6.5 Saum .081 freebore...

Hornady brass, 210 Fed primers, 139 Scenars

I did Chrono all loads from the start. Went from 2830 to 3179 at 66 gr. 64.5 grain loads averaged at around 3100, which is still below what I was getting with H1000.

Well I started at 58 gr 8133 worked up to 65.5 a half grain at a time no pressure signs at all, 66gr blew a primer...So I dropped back to 64.5 gr, first two no problem third blew another primer! All pockets were tight when seated...Accuracy was 1 hole at 130 yds with the 64.5 gr load...Any clues?

Thanks to all who replied, I'll give it a go...

Anyone using this powder in the 6.5 saum? Just picked some up and looking for a place to start.

I just remove the hand crank and insert the shaft in my drill and tighten. Seems to work fine...So what is the need for an adapter? Am I missing something here?