Recent content by Dshooter

Anyone??

TTT

Looking to buy a couple Alpha type 2 mags (308). If you have 2, let me know. Thanks

What powder in the 7SAUM? I'm running a 28" 8.75t and mine sees pressure with several powders at 2975. Not to mention shoots like crap.

I agree with above^^^^ I would be very pissed off. If I send you a dummy round or 3, I want it within .005. It can and has been done thousands of times. And his "old" reamer should have the specs on it. Not a very good smith IMHO. I would send it back, make him set it back .100" and re-chamber...

Would someone like to split? I could use 150 pcs of brass but don't need the dies....

Use a Rem700....22-250 would be a great 500yd rifle with heavies. Brass is easy to find and that cartridge is forgiving in the reloading dept. Get yourself an 8 twist or faster barrel with the 70-80gr bullets; it should be a shooter.

^^^^ here ^^^

Good to hear....I have one headed his way this week for a savage

Hey guys I asked a similar question trying to find out which bottom metal was closest to factory savage. Low and behold it's outsourced to Accurate mag, which I did not know. I have the choate stock for drop mag and what is the final vote? Go CDI or should I put in the accurate mag bottom metal...

They sure do....and it works great in a perfect world as in, the lugs are true to the bolt face and the action face is true to lug. Some people do run a virgin action with aftermarket barrels and some are OCD like myself and have them trued up

Cat64, silly question but after you FL your cases did you also check your case OAL. Probably need to trim them before trying to chamber, mine all grow after FL sizing. They might be too long

Hey guys, thanks a bunch for the recommendations. Called Rayhill and he called me right back. 7-10 day turnaround!! That's great! A little pricey but I'll try him out. Also call RW Snyder and left 2 messages and apparently he's too busy bs-ing here on the hide to return calls. Oh well....Rayhill...

Hiders, looking for a good smith to true up a savage action and cut a barrel down. Trying to find someone with a short lead time. I understand its getting to be that time of the year but not wanting to wait 8-10 weeks. Thanks

Hey fellas, I am building a cheaper utility rifle from these savage parts I have laying around. Was wondering which aftermarket bottom metal is closest to factory savage? I was thinking CDI but never owed one. It's going in this Chaote that is cut for savage bottom metal. Thanks