Recent content by flyingtxn

My family is in delta and GJ. You close?

I would do $700 plus a 30mm Zrodelta QD mount which is better than the bobro

Where in Colorado?

Any one done any reloading for the OMEN 2.0 300 WM with the 230gr Berger OTM Hybrids?

The primer blowing is load dependent and related to gas block setting. With a suppressor, you have to move it to 1 or 2. Once it is dialed it wont do this. Do be careful on the Black Hills. They loaded some seriously hot rounds that the Navy rejected and they are selling to civilian now or...

I have one and upgraded to the OMEN 2.0. It did require some changes to the gas block to dial it in. Shooting at the R4E/Nemo sniper school, it was obvious that you had to dial the rifle to the factory ammo you were using. The black hills was HOTTTTTTTTTTT and required a different setting...

I just got a Leupold Mark 8 with 56mm objective and 35mm tube. The seekins rings (1.26") are not high enough. Measuring it looks like I will for sure be safe with 1.5" utilizing the scope caps. I would prefer at Quick Detach (QD) mounting system. Any suggestions would be appreciated. Thanks...

Also, built in cant is fine but I most likely will add and ACI/ACD bracket as I did with the nightforce and DE setups on my other guns.

Awesome, thanks guys! The scope will be here shortly so I will measure to see what clearance is needed and then start narrowing it down. Are all of the above quality products? Any better than the others?

I am mounting a Leupold Mark 8 56MM Reticle with 35MM tube on a NEMO OMEN. Any suggestions on mounts/rings? I talked to Larue and they only have a 1.93" which will be super high. Thanks in Advance! Dev

Just a newb checking in from Montana. Interested in long range shooting, mostly hunting. Platforms include a NEMO OMEN, Defensive Edge 338 and lots of other "stuff". Thanks! Dev