Recent content by Forward543

The firing spring is compressed, and the pin retracted, when the bolt handle is lifted. It acts on a cam in the bolt body. It does not engage the trigger sear until pushed back into battery, and the bolt handle lowered. You cannot have a slam fire, unless you have a failure of trigger sear and...

Preferred barrels is running carbon pre fits.

Tracking for short action right hand. Ordered 3/10.

Meh, 10 is fine. Covers shit conditions. Not meant to be a difficult stage. Sheldons sugestion is best. Make it a big/ little. Those stages are better anyway.

What order dates are being shipped. Figured it is easier to check what order dates are getting tracking, than to call ARC.

Any updates on shipping?

Go find a sig hunter games/ hunter one match. They are the same base idea, without attempting to be blind. You can use anything you want, and practice your setup.

Check out preferred barrels. https://preferredbarrelblanks.com/pre-fit-gun-barrels/

Seekins or MPA. Both are great companies. Seekins makes every part in house, except the trigger. Round does not matter as much as shooting alot.

For todays lesson, do you know how to that thread was cut?

Sent funds for pro curves

Amusingly enough, with the 109 eldm, going 2860fps, 27"hg+/-, 35%humidity; I run a .299 g7. Enough to keep me within .1 mil+/- at 1017yds. Jury is still out on the reliabilty of this projectile holding .2 mil at that range. Aside from that, a good chrono goes along way to getting 1 variable...

You may ask the MD. Round like that will wreck targets.

are you seeing reports of an AD? Or just the striker skipping over the trigger sear and not being ready to fire? I have an archemedies with a tt diamond. When set below 5 or 6oz and runing the bolt super agressively, the striker is not set on the sear. Never had an AD. Just needed to be reset. I...

Where did you get 131s? Thought they were dead