Recent content by jasonk

Rich Emmons posted this in the PRS Finale thread, but I wanted to bring some more attention to it here as well. For all you new guys wondering where to start with equipment, this could be of some help to you. This is the gear that was used by a good...

Alright, I'm working on a more in depth write up, but to cover the few questions I've seen on this page. I've always ran my action pretty dry. I can't say if it's more or less smooth than a Defiance because I don't have one handy. It's better than my custom Remington rifles, probably not as...

I likely have more rounds through a Havak than most anyone in the US. Accuracy has been phenomenal.... I have to put kids to bed here in a few and then I’ll write up some more.

Internet HIGH FIVE!

Just testing something....

milehighshooting.com AI's are their #1 thing and they can do it all.

My lathe says "gunsmith" right on it....am I qualified to post in this thread? ;)

The 5.11 RESPONDER 84 ALS BACKPACK has a ton of pockets, would have to strap the tripod outside likely depending on size. 5.11 Tactical 84 ALS EMS Backpack | Official 5.11 Site

Can you post a picture or a link to the hand guard you're using? Can't believe there are no set screws or anything, odd. If no screws then as JBRC said use acetone to degrease real good. You could also put the part in the oven after some acetone to bake out more grease, low temp of course...

A new threading tool, some bits for the tool and another cut off tool holder. Sadly I had bought a whole lot more last month with only 20% off....but oh well.

30%...ah man....I don't even need anything but that's going to cost me money!!

PCR, what's that you're using with the clamp to hold the action in the stock?

Pipe Tape here.... Pasco 9064 4" x 50 ft 20mil Pipe Wrap Tape

I'm guessing he meant from the muzzle to the shoulder.

Thanks!! So Series 1111 I assume??