Recent content by Joe Kidd

Shot a stray tomcat at 275yds off-hand with a Ruger varmint 243. Centered the crosshairs high then squeezed about 8" high off the cat. A lot of luck, I'm a poor shot standing.

Just in case a TS should come ashore this spring, better ship that to my house for same keeping. ;)

NoFail, is your avatar photo one of them new-fangled bullet pullers?

Tim, PM sent.

That's the really good chit!

Some helpful info here M118LR duplication load - Page 2 - M14 Forum

The 9th edition does not have data for the 208 amax in the 300WSM. Only has data for the 178 amax and like weights, 190 btsp and 220 RN.

Be glad to. It'll be later tonight.

I ran some H4227 for awhile. At least it'll give you less muzzle flash and a more complete burn. You'll have to settle on slightly slower velocity, but full-house loads in that gun are quite rough. 5 shots with a glove is about all I could stand with that piece. +1 on the small rifle primers...

Is this mil-spec match brass? Is it worth buying for .50 ea?

Hornady one-shot spray. Probably a few Ho's made it.

About 55% in the southern summer months is about atypical with an average AC system. As a HVAC tech anything over 60-65%RH can contribute to mold formation. A good 13-14seer system with dehumidification can maintain 50% easily.

Good find. I shoot these in my .300 and there are none to be found!

Thx. With powder scarce I had a chance to buy a 8#H1000. Figured I could use it in the mag with heavy pills.

Nosler is indicating around 77grs +/- before compression. Ref pp 452 #7 for the 190gr . I'm guessing 75grs give or take for the 200gr with the same OAL.