Recent content by jstone

if you use this as something that you may need to defend yourself with and you cant swing a better sight you can send me your address via pm and I will send you a metal rear sight. I have to look and see which ones I have but I know I have a few. it may be BCM troy or an ARMS, but it will be...

if you are able to use a bullet that is not monolithic the nosler partition is great. it's available as a 60 grain bullet. the top section expands rapidly, and the back half allows for great penetration. the bullet is available for reloading and federal used to have one load using the partition.

I really like my sionics 12.5 mid, chrome lined 5r 1 in 7. it's been to hot in Vegas to go to the range much since I got it, but everything appears good from first impressions. you can get it with the standard gas port or there reduced gas port for suppressor use. sionics makes great products...

you said ceramic plates are prone to cracking. one of the definitions of prone is likely to happen. so you clearly didn't say it is unlikely. you stated this is a likely problem based on your word selection. the attempt to clarify later for a home user this is not likely doesn't change what you...

for moat people wearing ceramic plates regularly are doing it for work like you. you shouldn't have to be thinking about how fragile your plates are, if cracking was truly an issue nobody would be issuing ceramic plates. thanks for the info, everyone I know with work plates says the same thing...

ceramic plates cracking is blown way out of proportion. can it happen of course it can but is it likely to, no. ceramic and ceramic hybrid plates have been used for a long time, and the cracking is something that shouldn't even truly be a concern. the military has used ceramic plates for years...

don't waste your time with steel plates its garbage. I personally wouldn't even wear steel, I don't care how much bed liner you use your going to catch fragment somewhere you don't want. I just picked up another set of level 4 plates that are just over 5 pounds and roughly an inch thick multi...

out of the ones you have listed the Magpul pro is my favorite. The front post gives you two options out of the box. They come from the factory using a very fine post, if you prefer the standard size it just take a couple minutes to adjust it. you can always get your preferred set and swap the...

anyone who is using a red dot and doesn't get a clear image due to astigmatism use you back up iron sight. when looking through your back up iron sight the dot will become clear. if I ever use a red dot without magnification my rear back up is alway in the up position. it is amazing the difference.

I found a video of yours when I saw the targets I knew I could never finish half the course with irons. I have a couple older 22 rifles I would love to attempt this with. Thanks for the information.

Where is this event held, and have you ever had anyone attempt it with an iron sights?

Never seen it done with type 3, but I played competitive paintball for years and have had many markers redone. The dimensions and tolerances for the markers being used were probably tighter than for a lower, and I never had any problems. There is not a lot of color options for type 3. If its...

If anyone is looking to do any conversion for the MRP Nefarious Arms is worth looking at. They have done excellent work. I will be sending in an old CQB upper for a 12.5 mid conversion, and at the same time having the chassis milled to replicate the KAC 3.1. I have heard of some long waits...

Where are you located you're on a forum with people all over the country possibly willing to help. At least you reached out for help when you realized something is wrong, and got it fixed. The big problem lies within small problems that my go un noticed that could have catastrophic results...

If you want to get the best accuracy you can, and are not happy with your cl barrel. Get a hold of marvin pitts at nefarious arms. He will convert any barrel you want to work with the mrp. [email protected] is his contact info. If you google him you will see his work, and get info on...