Recent content by mark5pt56
-
My New 6 GT just finished Break In
https://sebrests-usa.com/ar250-rimfire-and-air-rifle/ I don't see where you would purchase these rest. Any experiences with the Rimfire one?- mark5pt56
- Post #6
- Forum: Bolt Action Rifles
-
My New 6 GT just finished Break In
Dang, not cheap! holy fook- mark5pt56
- Post #4
- Forum: Bolt Action Rifles
-
My New 6 GT just finished Break In
Awesome! who makes that front rest?- mark5pt56
- Post #2
- Forum: Bolt Action Rifles
-
-
-
Dumb question: Baking Sig FCU to cure loctite?
You can speed up cure time---but, you do you with a 320-AND adding 2 screws and thread locker to that mechanical mess. You may have an innocent question or are baiting since it's a 320- mark5pt56
- Post #2
- Forum: The Armory
-
Scope ring height
Heck, you have some running 1.93 on AR's now! The 1.5 is not that tall at all, pic below, even on a bolt gun.- mark5pt56
- Post #15
- Forum: Semi-Automatic Rifles
-
Before & after eye surgery, POA vs POI shift
Research parallax error with implants and cataract surgery. I worked with an older gentleman some time ago who had a similar issue-bottom line is if the implants are not perfectly centered, you will have it. Of course there's a more in depth explanation available, the articles may be helpful...- mark5pt56
- Post #2
- Forum: Observation & Sighting Devices
-
Xero C1 Pro - v3.30 update
On the bench utilizing it's supplied tripod.- mark5pt56
- Post #184
- Forum: The Armory
-
Xero C1 Pro - v3.30 update
A couple more sessions since last week, 100 rounds, all captured- mark5pt56
- Post #181
- Forum: The Armory
-
-
Bushings and expander mandrel? .223 to start
Excellent! I really appreciate the advise.- mark5pt56
- Post #9
- Forum: Reloading Depot
-
Bushings and expander mandrel? .223 to start
I see they offer .2220 and .2225, without getting to far down the rabbit hole, .2220? Open to suggestions and not having to use the media helps reduce the process.- mark5pt56
- Post #7
- Forum: Reloading Depot
-
Bushings and expander mandrel? .223 to start
Lake City, the first lot/rifle will be 04 and the lot I will use on the other 2 is LC12, annealing each firing. Okie, I'll try the .242 and .243, maybe I can measure after the bushing to see where the insides end up and choose mandrel? Or if there's 2-3 sizes I can work from. I will be moving...- mark5pt56
- Post #5
- Forum: Reloading Depot
-
Bushings and expander mandrel? .223 to start
I think I have this correct, confirming in the event I'm missing something? Reference, moving however so slowly from the polished expander ball on standard RCBS 2 piece die set. I was using the die with the spindle removed and then a Sinclair expander mandrel-I know, over working the brass. My...- mark5pt56
- Thread
- Replies: 8
- Forum: Reloading Depot
