Recent content by Mojo Daddy

Years ago when I got started into reloading I bought a Lyman case gauge and started to crank out hundreds of Lake City 308 brass. I put several hundred rounds through my Remington 700 without any problems. One day at the range I had a case head separation and alarm bells started going off in...

After reading the owners manual I read the barrel conditioning and accuracy section, it says " To achieve the best results for accuracy you should clean the chamber and bore after every round for the first 25 rounds and then every 10 rounds up to 100 rounds." Better take plenty of patches and...

Went by Buds and picked up my G-2 hunter yesterday. It will be several weeks before I can get to a range to put it to the test. My initial impression, this is one well built rifle. The ergonomics are great. This is one damn fine looking rifle.

I order this same rifle on 22 Feb. from Bud's. Still waiting.

Rinse your brass in a bucket of water with Lima Shine in the rinse water. Take brass out of water and the roll on a towel to pat dry. I then put in oven at 175 for 1/2 hour to dry.

Try thinking ahead people. I have been stocking up the past 10 years knowing shit like this is going to happen every now and then. When things settle down ( if the every do ) then start stock piling big time. I got a shit load of primers that I paid $12.00 a 1000 for when times were good.

Formal naval person, that .32-.33 ex pander die sounds like a good plan. I'll check it out.

I just measured another box of brass that I had stored away. This brass is measuring 1.623, .007 below minimum. I am going to load and fire these through my bolt gun and use the paper clip method to check for case bulge. If no bulges I will keep this brass.

I set up my Hornady dies on my Dillon 550 to re size my once fired LC .308 cases. I followed the die instructions, re sized 500 cases. While shooting these cases at the range I had two headcase separations. Bought the RCBS precision mic to get a precise measurement on my case head space. My...

Re: Guys with SS media cleaners... I run the cases through walnut media in my vibrator tumbler then deprime, resize, trim and swage. After all that then I run them through the SS treatment.

Re: Giraud Trimmer Best money I have ever spent. Giraud trimmer is worth every cent.

Re: Giraud Trimmer came in! Giraud case trimmer, the best $400.00 I have ever spent. I trimmed 300 223 cases this morning, it took me twenty minutes.