Recent content by MrOneEyedBoh

Appreciate all the help, but yes I used the roll pin punches. Everything is aligned. The hold is just too damn shallow... Crazy I know. The guy I used was recommended a lot here, so it's not some Joe schmo. Pretty much told me to kick rocks at this point. Ok fine... Just wondering why it went...

I did use a bit and nothing came out. Unless I'm not pushing hard enough and stuff is super compacted... Im at a aloss too

It will. It's definitely the ejector not sitting into the bolt correctly.

Yeah I assumed that but I wanted to double check

Thtas what I was saying, yeah, its the same all the way down.

When you said pin clearance relief, is the hole that is drilled in the bolt one size all way down? OR is it drill like this ( crude image, but hopefully you get it. ) Is the hole for the ejector cut all the same OD all the way down like in #1? Or is it like #2 and is the hole somewhat shaped...

Excuse my intellegence lol where is that located? Assuming you mean Serial itself? E649 is what it starts with. Asking just because mine doesnt have two letters - just what you see

Thanks. Mine is a 308 if that matters at all. The bolt functions within the gun fine in terms of movement/action etc. Just the Ejector button protrudes past the face of the bolt, thus not allowing the round to sit flush into the bolt/against the face.

I dont... i honestly dont know much about these things. I took a few long range classes, learned how to shoot and I shoot for fun. I appreciate the help guys..

This is getting unreal. So my specs on the ejector are damn near the same. Here is where it gets crazy. The hold is WAY smaller... 1.113" is what Im getting. I used a bright ass flashlight and looked in the ejector hole and it doenst look like there is anything in there at all. Im truly starting...

Cant... it never recesses past the bolt face.

Perfect. I'll check later on

Thats what Im thinking... The guy that did it is pretty much saying since I didnt shoot it since I got the bolt back, its up in the air. Well God strike me dead, it went out working and now it doesnt. The only thing that changed we fluting of the bolt that was tore down by them thus leading me...

The extractor has always been there. Yes the cartridge seats properly into the bolt with w/the ejector removed. I did, nothing came out.

I will do that tomorrow and report back