Recent content by poptart4YALL

You mean it looks like a R700... you don't say

If he already knows the measurement for his chamber there’s no need to fire form. He’s full length sizing and the brass is clearly longer/larger than what he needs. He just sets up the die to give him the correct shoulder clearance and load them.

How hard is it swap between small and large. I have been using the RCBS hand primer and that’s a bit of a pain in the dick.

Was wonder fit any body had experience with the frankford arsenal perfect seat hand primer? How’s the adjustability and repeatability? Any other thoughts or concerns with it?

How are the 155’s working for you? I have an 18” bolt gun and loaded up some Hornady 168 Match and they’re going about 2539FPS with a can. According AB they go transonic around 955yds. I’ve always heard the issues with the 168 SMK’s is not being stable while going transonic and I would suspect...

I’ve shot all the .22lr matches at peacemaker so far. There are no magazine limits. Most stages have a max round count of 15rds. The first two matches I shot my 10/22 with the flush 10rd mags no issue. I picked up a 15rd mags and have been using that ever since. Mainly because there’s no good...

I know people have had issues with the lube on the bullets gumming up there barrels and cause accucarcy issues. You may have the lube gumming up the chamber and case not extracting as easily as they should. I remember hearing about the long range shooter of Utah guys having issues with this and...

Well obviously something isn’t to spec. Measure both the base and mount to find out which one is closer to spec. You might be able to contact the manufacture of either one and get it replaced. Or like you said have a gunsmith open up the slots to spec.

Hmm, maybe just maybe he like purchasing ammo that gets the results needed for the match. I’ve shot also all types of match .22lr ammo in my rifle. From from Lapua, Eley, Wolf, RWS and so on. And you know what, CCI SV is up among the best. Depending on the lot the SD might be slightly higher...

Your first problem with the cases hitting the bottom of the die is likely caused by the case insert slide/slide cam not going far enough forward. If your not priming on the press you still need to press the handle forward to get that to slide to travel fully. Or you may need to adjust the...

Little more data on this. We’re both planning on using LC brass so neck wall thickness will probably vary. And we’re trying to avoid turning necks while getting consistent ID and bullet tension. My plan is to use a bushing die without a bushing to bump the shoulder back and the then size the...

Hey I’’m that friend!

Oh lame. Stock still more expensive. Can I have my old scope back now? -Poptart

Hey look your stock costs more than my scope that's on it. -Poptart

That's what I did the first time around. It works well, plus the targets are generous enough for the elevation error if your hold is off by little you'll still gets hits. I dial most of the last match after upgrading my scope to the Bushnell DMR, which works well also. The main problem is only...