Recent content by QuickOne

G4 JAE. All of my JAEs have the longer arca for end on them, it’s just a more expensive option. Just more $$, ultimately. Also, my G4 JAE has the ACC Elite adjustable latch assembly. Both are needed to properly align the mag and maintain bolt clearance for my 22LR. All I can see that they...

Since writing this, I have also switched over to the JAE. Comparing both the Spuhr and JAE back to back, I just more naturally fall into the JAE. My Foundation showed up recently, but I haven't shot it yet. We'll see how it compares in the coming weeks.

I have two Spuhr SICS chassis available, along with two Spuhr arca grabber rail sliders. These are great chassis, I'm just switching things up. One of them was clearanced for a Trigertech Diamond on a RimX to clear the adjustment screw for the second stage. Pics attached. Both chassis are...

I wanted to get the view from the Hide on an optimization I'm working through. I've been shooting PRS for a few years and am still working on optimizing my setup. I'm down to the stock/chassis and figuring out what works best. I wanted to get the opinion of the Hide on choices. Note all...

Both are now SOLD

The AT-X with the bridge is now SOLD!

I bought two AT-Xs Gen 3s to use for PRS competition and have decided to go a different direction. Both rifles are chambered in 6.5 Creedmoor, include the folder, and the light trigger spring already installed. From there, one has a long red top bridge, and the other has no bridge. The one...

Gah! And here I am just stumbling on this now. Hopefully spring comes soon, otherwise my scales might fill up with little kernels...

Firmware update solved it. That's much simpler than changing the ZH as I did all weekend! Thanks @Evintos

Actually, I just checked and this was apparently added to a new firmware for the HUD. Even though I just got this last week, it's apparently running 1.01. Will update firmware to check! Thanks!!

That doesn't appear to be a setting in my Settings Page. All I have on the HUD is: Bluetooth Stage Timer Screens Single Tgt Setup DOPE Card Resolution System About is that setting buried in one of these somewhere? I couldn't find it, nor could I find reference to it in the HUD manual.

Resurrecting this - Can anyone provide directions (or a link to them) to do this? I have the HUD and haven't been able to figure out how to do this. It can be achieved by going to Gun->ZH and adjusting the height, but this is tedious and easy to get wrong. I would much prefer to setup a...

Will try that when I get home, but I believe the mag stop might already be cut into the action. With the mag block in place, the action would not physically fit in to the chassis. The front trigger hanger interfered with the bolt/block, thus the only option was to remove it.

We took it out of my son’s chassis and run AICS mags with the Impact action without issue. I’m guessing it might be needed for other actions, but perhaps not the Impact.

Excellent. Thank you for the advice. Out of curiosity, are you using AICS or AW (or AX) mags with your Impact?