Recent content by skurtz

Re: 6 officers shot in Utah Smokeshwn some guys just don't get it....

Re: Northern Utah PCPR July 30th PM sent I have to drop out due to work schedule change. Hopefully someone can take my spot.

Re: Northern Utah PCPR July 30th Put me in also.

Re: Northern Utah PCPR June 25th Thanks for the time and effort to put this match on I had a great time. This was the first time I have been able to make it up and I will be back. Thanks, Scott K.

Re: Northern Utah PCPR June 25th That will be 4 total with Dan W. So, that will be Smokshwn, 3gunf1guy, BigBore, and Dan w.

Re: Shankster Needs Real Life Advise. I moved to NW Montana(Troy)and finished school and then went to college in Butte. I would have to say that NW Montana had a higher rate of incest than Butte. Anaconda I'm not so sure of, the smelter there sure did a job on that bunch.

Re: .280 Rem/ 7mm Express Rem, where is the luv? I have a 280 AI that pushes a 180 grain Berger at 2950 and only needs 22 moa to get to a 1000 here. I wish I had time to tweak it some more and see what it can do further out.

Re: Always Been Proud of Living In N. Idaho Until Now I grew up not 4 miles from the Yaak river in NW Montana and I don't recall any white supremacist activity. Lots of that shit in Idaho by Hayden Lake and we had the Montana militia down by Noxon, but not by Troy that I remember. Of course...

Re: Rocky Mountain 3 Gun match We'll be on the Texas/Utah squad. We shouldn't be to hard to pick out, just look for the loud bunch.

Re: Rocky Mountain 3 Gun match I will be there also.

Re: PAC NOR Barrels/Action Truing I had them put one of their barrels and a muzzle brake I supplied on Remington 700 LA. The did a great job blending the brake in and they were right on time.

Re: 280 VERTICLE DISPERTION Fire forming is a real pain, I am pretty time limited with work and would rather just buy the brass load it and go. Plus the idea of having to run the extra rounds through it and shortening the life of the barrel doesn't please that much either. As far as accuracy...

Re: 280 VERTICLE DISPERTION I have a .280 AI that is pushing a 180 grain Berger at 2940 out of 28 inch stainless PAC-NOR. I only need 22 moa to reach 1000 at this altitude. It shoots about .6 moa and if I had time to make a few adjustments I think I could tighten it up. If I had to build...

Re: DPMS LR308 question Depending on whether it has a lock nut you may need to add some heat to help break it loose.

Re: 3 gun question I ran a Rem. 1187 for 5 years and I now have been running a Win. Sx2 for 4 years. Both have their issues, remingtons can be picky with ammo and magazine springs, and Winchesters (FN's) have issues with the magazine shell catch spring. Drill out the gas port on the...