Recent content by Yoteman38
-
Y
Gunsmithing Issue with AICS chassis to action fit
After I put the action back in the chassis and got the action torqued down, there is still a gap but only a small one. The rear action screw now is only about 1-2 threads short. I've seen actions in factory stocks look like this, so I guess it's all good.- Yoteman38
- Post #8
- Forum: The Armory
-
Y
Gunsmithing Issue with AICS chassis to action fit
Thanks All. Put the action back into the AICS and torqued both action screws to 53 inch/pounds per the instructions. No issues with trigger, safety or mag feeding. However, even though the gap is cosmetic, it still bugs me.- Yoteman38
- Post #6
- Forum: The Armory
-
Y
Gunsmithing Issue with AICS chassis to action fit
Thanks for the quick replies. No. The action is not sitting on the skins. I removed the skins in order to install the action. Everthing on the chassis appears to fit well except the gap under the action tang. The magazine works well, not too tight and not too loose. If the gap is designed...- Yoteman38
- Post #4
- Forum: The Armory
-
Y
Gunsmithing Issue with AICS chassis to action fit
Hello to all. Long time lurker, first time poster. I recently bought an AICS 1.5 short action stock (chassis system) so that I could drop my 1972 vintage .243 Varmint Special into a tactical type stock with magazine capabilities. This is the latest edition AISC that recently became available...- Yoteman38
- Thread
- Replies: 7
- Forum: The Armory
