• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Search results

Search the forum Search Articles
  1. Y

    What products can I add to Devcon in order to make it black?

    Just go to local paint store tell them you need a little bit of there tint they use for epoxy probably need to take own container
  2. Y

    Gunsmithing Tikka T3 bolt problem

    Sorry but also on brownells there was a kit for a bolt that said it was for a t3 but after looking at it I think it was for a 595 I also was on mid west gunworks couldn't find out if it was available but it did let me start the check out wasn't sure if you tried there
  3. Y

    Gunsmithing Tikka T3 bolt problem

    Was on brownells noticed they had this parts kit for tikkahttp://www.brownells.com/rifle-parts/bolt-parts/bolts/parts-spare-for-bolt-tikka-prod30972.aspx not sure if it's the one you need kinda expensive for just needing a pin
  4. Y

    Gunsmithing Tikka T3 bolt problem

    Have you tried fastenal I have taken parts to them and had them match up a pin before or Tacoma screw products may have one to not sure if either one of them are near you if they are might be worth a try hope you get it figured out and good luck
  5. Y

    Gunsmithing 7mm Wby hunting rifle

    If you can't find someone with a Reamer you could always rent one at 4 D reamers
  6. Y

    Gunsmithing Bedding with or w/o coating?

    I have done it both ways if I do bed before paint I cover bedding with tape to keep paint off. Painting the bedding makes me feel like I'm trying to cover a crappy bedding job up just my 2 cents
  7. Y

    Gunsmithing Bolt won't close on factory ammo

    You said it looked like there was a Burr In the throat. Does it look like it could be some copper from the bullet or does it look like steel have you tried using a tight fitting bore brush see if that will get it out. Maybe try some J B bore bright good luck let us know what you you figure out
  8. Y

    Gunsmithing Cerakoting barreled action - oil bleed out?

    Yes I have had it even after 2 or 3 baths most of the time it has not Hurt The finish it didn't bleed out until finish was dry
  9. Y

    Gunsmithing Blueprint Remington 700

    The problem is if you don't blue print the action and it doesn't shoot as well as you would like there is that question in the back off your mind what if I had blueprint I have seen a rifles shoot very well both ways i to believe most of accuracy comes from a good barrel and chamber a lot of...
  10. Y

    Gunsmithing My PTG after action report

    First of all want to thank you for your service to our country. And it's good to hear some one have positive things to say because everyone always points out the negative in everything. And I'm really a nobody to and I have had some mistakes happen but ptg has always done every thing they could...
View older results
Top Bottom
Back
Home
Forums
Merch
Alerts