Search results
-
308 Remington700 Target Build-Plan
Re: 308 Remington700 Target Build-Plan Aluminum compared to Steel, strength is definitely different. Apples to Oranges. Buy what you want, they will both work for plinking but I want my $2K nightforce to stay put.- Chabrone
- Post #23
- Forum: Bolt Action Rifles
-
-
Gear Question about Savage 110BA .338LM...
Re: Gear Question about Savage 110BA .338LM... Because it was dented, the repairs were prob just a fit issue and $10. I'll pm you my address. Sounds like good service to me.- Chabrone
- Post #2
- Forum: Bolt Action Rifles
-
300 rum reloaders, need some help
Re: 300 rum reloaders, need some help I use Remington and have good results. 180 and 200 acubonds for hunting have performed well on elk. I don't have to shoot twice. I don't turn necks anymore, I just don't have time with small kids and more demands at work. I measured mine and .337...- Chabrone
- Post #2
- Forum: Reloading Depot
-
Gunsmithing Duracoat on threads?
Re: Duracoat on threads? Sounds like a plan. Keith I will be sending u a few bolts for knobs soon.- Chabrone
- Post #8
- Forum: The Armory
-
Gunsmithing Duracoat on threads?
Re: Duracoat on threads? Thanks everyone. I played with the fit on my brake and it is very tight so I may spray it while installed on the barrel. How do you spray the inside of the brake evenly without getting drips? Or should I even worry about it? I'm not hung up on cosmetics but don't want...- Chabrone
- Post #6
- Forum: The Armory
-
Gunsmithing Duracoat on threads?
I searched as many of the duracoat threads as I could but didn't see anything about getting DC on threads (muzzle, brake, shroud, action, screws etc). Obviously I am more concerned on the finer threads. I am about to spray my first gun and would like to do the threads but want to make sure it...- Chabrone
- Thread
- Replies: 7
- Forum: The Armory
-
700 LA Question
Re: 700 LA Question The two small holes on rear left are for a sight, I think. I have an older 700 with the holes and a newer one without. I am not sure what hole on the right u are referring to but mine have them and they aren't threaded. I think they are just a blowout hole in case shtf.- Chabrone
- Post #2
- Forum: Bolt Action Rifles
-
I Had No Idea .... cover song
Re: I Had No Idea .... cover song <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Sebben</div><div class="ubbcode-body">Probably the most historic cover in history is Johnny Cash covering NIN's Hurt. This song almost brings tears to my eyes. <object width="425"...- Chabrone
- Post #21
- Forum: The Bear Pit
-
Suppressors Rare pistol requires no suppression....
Re: Rare pistol requires no suppression.... Christies is gtg!- Chabrone
- Post #13
- Forum: The Armory
-
Gunsmithing Scope mounting procedure?
Re: Scope mounting procedure? I have run 60 in/lbs on the base screws and cross bolt nuts. 15 in/lbs on the rings screws. I only loctite the base screws and have never had ring scres come loose (except that time I drove 40 mph down washboard roads hunting antelop in WY). Lapping isn't...- Chabrone
- Post #2
- Forum: The Armory
