Search results
-
WTB 223 AI die set
Looking for a set of 223 AI dies.I dont need anything special a standard die set will work fine. Have something you dont use anymore? PM me with details- colchester
- Thread
- Replies: 0
- Forum: Buy - Sell - Trade Archive
-
Gunsmithing Help with spec on 243 reamer
I am going to purchase a 243 win reamer from PTG. I dont want to turn necks. This will be used to chamber for bolt action rifles only for target and varmint shooting. I usually get 0 fb 1* 30 on all my reamers and throat with a separate 1* 30 throater. Suggestions for the other critical...- colchester
- Thread
- Replies: 6
- Forum: The Armory
-
Gunsmithing Need AR-15 Tenon Details
Couple of questions on ar-15 barrel tenon. How much clearance between bolt nose and breechface? What are the details on the chamfer on the breechface, what angle and how deep does the chamfer go? TIA- colchester
- Thread
- Replies: 0
- Forum: The Armory
-
Gunsmithing 2 stage Jewell Trigger Setup
Is am hoping someone here is familiar with this trigger and can help me set it up.I tried following the supplied instructions but could not achieve the correct 2stage effect, or even a good feeling single stage pull. I followed up by calling Jewell they were less than helpful since this trigger...- colchester
- Thread
- Replies: 0
- Forum: The Armory
-
Gunsmithing ?? ON Gre Tan reamer / mandrel
I have a gre-tan bolt raceway reamer and mandrel and have a ? re its use. After reaming I install in a fixture and indicate in 2 places on the mandrel. I have had difficult getting the reamer/mandrel out of the action after I have it dialed in.I dial on the smaller dia end and leave the larger...- colchester
- Thread
- Replies: 3
- Forum: The Armory
