Search results

Thanks for the heads-up in the change in production models. With the removal of the 653611 I won't be following this one. Hoping someone at Meopta is paying attention here.

Tagging along here as I'm also in the area. Have 1 rifle qualified for the 600 yd but have yet to shoot on that line.

Charge and velocity?

It occurred to me this morning that the problem is obviously in the bullets and that I should look at them by themselves (without being loaded). Lot A Bullet ONLY Measurements: Bullet Base to Ogive: 0.657" Overall length (bullet base to tip): 1.231" Lot A Bullet ONLY Measurements: Bullet Base...

Unfortunately I don't have anything to add but would like to know if that log sheet is available to download...

Doing a couple of ladders for a 6.5G AR and had to move to a new bullet lot from ladder 1 to ladder 2. Bullets are 123gr. Hornady ELD-M, using Redding dies. Found something I find very peculiar: Everything is identical other than powder type and weight: processed at the same time, through the...

Bench is plenty sturdy. If different lube doesn't work my next cheapest solution is sending the die to Forster. Hopefully skip buying a press and keep my shekels for a Magnetospeed.

I think you're right. Other than that I'm wondering if there's too much flex in the press but it would surprise me with a smaller case like 6.5 creedmoor.

@padom Good questions and thanks for the digging. Responses underlined below. How do you know your shoulders arent bumping back? You havent mentioned taking measurements with a case headspace comparator. Yes - using a Hornady Headspace Gauge. Do you have the Hornady Case Headspacs gauge...

Thanks all for the information. I'm using a Lanolin based spray on lube from a local reloading place. Forster did recommend trying a different lube and will be sending a sample. If that doesn't do it, I may send the die in. @TJC regarding FL size or shoulder bump, I thought I was trying to...

Equipment: Tikka TAC-A1 6.5 Creedmoor Hornady brass - 1x and 2x fired Trimmed to 1.915 after 1st firing (no need after 2nd) Forster Full Length Sizing Die Lee Classic Turret Have the die/press maxed out and cannot get the shoulders to bump on 1x or 2x fired brass. I haven't shot the 2x fired...

Jefe: How far are you seating off the lands? I'm quite a bit longer at 2.273 CBTO for .020" off. Using Hornady 1x fired brass I also haven't been able to (likely unneeded just yet) bump the shoulders.

FWIW I had a Vortex PST 2.5-10x32 fail on a SCAR 17 not once, but twice. Both times in an ADM Delta mount. No problems (though still early) with a NF 2.5-10.

Thanks for the help. I ended up snagging a set on eBay that I must have overlooked.

Coming up on a time crunch to land some 6.5mm Creedmoor dies and can't find any Forster dies in stock (Graf's, PV, Cabela's, Optics Planet, Midway, Brownells, Midsouth, etc.) I'm looking for a FL sizing die and the micrometer seating die. I almost hate to post it but is anyone aware of a...

Thanks guys.

Thanks for the input. That's what I did for the last scope that I had used in the mount Vortex Viper PST 2.5-10. Had to send the scope in for warranty work and they replaced it (free of charge) claiming it had been over torqued in the mount. Wanted to play it safe on this one. I may start...

I've looked at the manual but am a bit confused about the torque spec for a NF 2.5-10x32. I'm mounting it in an ADM Delta. Any help?