Search results

Thank you. I appreciate your detailed process. Sent from my iPad using Tapatalk

Ok, thanks. I'll try to cut a case open to see if the inside has any deformities too. I'm already at the starting charge weight per Hodgdon load data. (23.0 gr). The pressure issue has me worried the most. Sent from my iPad using Tapatalk

No. I shoot at home on my farm. I walk 30 yards to my bench. Sent from my iPad using Tapatalk

I use a machined brass sleeve slid over a fired case shoulder. Measure that length, then measure a sized case with the same sleeve. It measures .002" shorter after FL sizing. Sent from my iPad using Tapatalk

Sticky extraction on occasion but not always. Don't look like this before loading mag. Come out of the chamber like this after first firing. I think the bore may be tight. Unsized virgin brass without a bullet chambers with resistance, bolt close feels tight. The early pressure signs with...

I sent my action, lug, and new Bartlein barrel to the smith. It was a custom job. Sent from my iPad using Tapatalk

Case head looks good, no ejector marks, etc. Always at least 0.015" off lands. 0.015-0.80" off lands. 0.002" bump on the shoulder. Not suppressed. Reamer was 0.050 free bore Sent from my iPad using Tapatalk

Once fired brass looks like this with 3 brands of brass, 3 types of powder, and 95 TMKs, 87 Berger VLD-Hs, and 95 VLD-Hs. Again, it does this with recommended starting load volumes and primers show pressure in short order. Sent from my iPad using Tapatalk

Happens with Lapua, Winchester, and Federal brand cases. It's 223 Rem brass necked up to 6x45. Primers start showing pressure signs at least 2 grains below listed max loads. Anything much higher than starting charge weights begin to flatten primers. It's even pierced a few primers at 1.5 gr...

I'm getting a ring imprinted on my brass that only goes half way around the case. This happens after firing. It is not present when it first comes out of the FL sizing die. It appears after firing leading me to think that the rifle chamber may be causing the blemish to appear. Image of sized...

162 ELD-M. Accurate bullet with a kick ass BC. Sent from my iPad using Tapatalk

100 yd 5 shot groups, prone position, with Harris bipod and rear bag, 10x fixed scope. Sent from my iPad using Tapatalk

I use MDT mag in my 6x45 and it runs flawlessly. Sent from my iPad using Tapatalk

My 6 Creedmoor Hornady brass primer pockets crapped out after 4 reloads. It lasts 15+ cycles in 7mm-08 and 308 though. Sent from my iPad using Tapatalk

Think of it this way: When a new iPhone hits the market, the demand around the globe is much higher and Apple has no trouble producing enough phones to satisfy consumer demand. If they were produced by the firearms industry, the wait would be eternal. Sent from my iPad using Tapatalk

Why can't production of H4350 meet demand? Why was there a shortage of .22 ammo for several years? Seems the firearms and shooting industry has a big problem in the area of supplying the demand of consumers. I can't understand why shooting sport manufacturers can't produce enough product to...

Goal: .25 MOA and SD Sent from my iPad using Tapatalk

I plan to build one for my next rifle. Sent from my iPad using Tapatalk

Great looking action Sent from my iPad using Tapatalk

I love all the 6.5s but I've got a soft spot for the 7mm-08. I've had a few and most have been real hammers. The 7mm-8 affords a great bullet selection to choose from and terminal performance is excellent. Sent from my iPad using Tapatalk