Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Watch Out for Scammers!
We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!
If your load stops shooting when it gets hot, back it down. Your barrel isn't done. Staying on top of the carbon is important Especially if you're running a tight neck chamber. Using a good bore guide will help with land wiping. With most good barrels copper should not be a problem. Unless the...
The initial angle is 1-30 halfway down. Then it goes to a more gradual angle to major land diameter. The final angle can vary depending on what reamer your are using. Kiff was the guy that came up with the term (bore rider) At one time Dave offered it in smaller calibers. A friend of mine did...
Needs new bolt. Also scope the locking lug recess on the barrel ext. It should be softer than the bolt. If it looks ok. Spec the new bolt for headspace to confirm no set back on Barrel ext. If it was mine I would put a new barrel ext on too. Not sure how they got enough of that powder in that...
The aluminum bar that runs the length of the forearm is rectangular. Probably only 1/4 - 5/16 thick. Not sure how you plan on drilling a hole that needs to be the diameter of your spud? Let alone how you will locate the drill or end mill precisely in the stock. You could drill small holes in...
Its not rocket science 4 grove will support the front of a live pilot reamer more securely than 5 groove. Even less support of the lands are canted (or what ever u want to call it) Spiral fluted reamer is the way to go. Carbide is even better. Chatter is only part of the problem. But I wont...
The only problem with CCI 450 is they are very hard. That's why I use them. Probably 25k in the last 15 years Not one failure. But I remember hearing guys bitching about them from time to time. If your going to run one of the hardest primers out there. You need to pay attention to all the...