Search results

I was wondering if anyone knew of a rubber foot replacement for the CKYE-POD triple pull variant. Nedved advertises a rubber foot that slips over the OEM steel claw foot, but I was looking for a straight up replacement/swap.

For anyone with a TFCT-24: Can you reply with the diameter of the top leg segment? I only have a TFCT-34 on hand which is ~36.7mm for the top leg segment diameter, and I know the 24 is a bit thinner. Thanks.

I was on the Spuhr site - https://spuhrwebshop.com/en/accessories/rails/ - and it wasn't clear on where the height measurements are taken for the rails (no schematics for any of the rails) If it says height of 10mm, 14mm, etc., is that measurement taken from the bottom of the rail to the very...

I have a brand new never used KRG Harris Bipod Direct Mount (Inline). $25 shipped.

I have an extra RRS BTC-Pro Atlas Bipod clamp that is unused. It was only taken out of the bag to do some weight comparisons against the new ARMS-LR clamp. $SPF %

SOLD. NO LONGER AVAILABLE. I have a used MPA RAT Magnetospeed Adapter for MPA BA, BA Comp, or ESR chassis. Details - https://masterpiecearms.com/shop/mpa-rat-magnetospeed-adaptor/?attribute_pa_rifle-type=without-suppressor This is the "without suppressor" configuration. Requires an Arca...

[SOLD]

I am selling a used Atlas PSR BT46-LW17. This bipod coms with the ADM 170-S Lever. PSR has non-rotating legs. Original owner. Purchased new from Brownells. Selling because I never really used this (prefer Harris) and also just acquired an Atlas CAL. $275 - SOLD PENDING FUNDS

Selling at Accuracy International 80mm / 3.15" accessory rail Pail Brown. This is AI part number: 25848PB It is used with nominal wear. $30 shipped. SOLD

I'm selling a Really Right Stuff SOAR Accuracy International Plate (BAI-AT). This is the original design which was replaced by the BAI-AT2. It is in excellent condition. Couple of finish scrapes from tripod use. This is for an AI AT or ATAICS (not AX from what I understand). $45 shipped. SOLD

I noticed that the stock on my ATAICS has a very slight amount of wobble/play, specifically the base of the folding stock has wobble where it mates to the actual chassis. Is this a user serviceable fix? Do I have to remove the skin of the ATAICS to get to some sort of screws? Thanks.

I don't post here much, but I wanted to share the results of the zeroing of my Eliseo R5 match rifle (NRA HP "Across the Course"). I've had my Eliseo R5 Remington 700 in 6mmBR built since February, but haven't had the chance to shoot it beyond 200 yards until yesterday. Was able to bring it to...