Search results

Awesome, thanks!

Along the lines of what I was thinking. Thanks. Where do you get the bar stock to make the sleeve?

I would be interested in the details if he would be willing to share. I have been contemplating this myself.

Friggin dang zombie thread!

What is the load you are running and the velocity?

Sooo kind of a long story on the barrel. It has less than 50rnds on it. I bought it from what I thought was a reputable smith. The chamber was cut so rough it looked like a 1st grader cut it with a sharp rock. The brass that came out of it looked horrible. Surprisingly it was very accurate even...

I have a AR barrel that I could utilize if it was set back. In other words, cut the tenon off and rethread. This would move the gas port back toward the action. Meaning the gas tube would need to be shortened. The same amount that is cut from the tenon. Is this a acceptable practice??

I have not ran 8133 in 338 yet. But I agree with the above post. It is slower burning than expected.

It did. I lost it.

Thanks! That's what I needed. Where did you find it? I looked everywhere.

Any one know where to find the instructions on how to adjust the AI Competition trigger?

H1000

Good to read about the stuff that really matters.

I would think that barrel life would be extremely high. Pretty mild cartridge at slow speeds with low operating pressure. Definitely better barrel life than a Creedmoor, and that is not bad at all.

It is based off the 6PPC. That cartridge a standard in bench rest. Should be very easy to load for.

Why does the 195 eol not get much love?

This would be interesting! I would think super slow powder such as US869. I have 0 experience though. Friggin Lazer beam!

Go figure, I just pulled the trigger on a 6mmAR.

Sucks man! Glad no one was hurt. I am in NOCO if you need anything.

162 Amax and Eldm is one of my favorites for years. I might check this one out. Don't know if the old 7 Creedmoor has another round of load development left in her.