• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Search results

Search the forum Search Articles
  1. N

    Maggie’s What are you drinking right now!?

    1554 and Samuel Smith's Nut Brown Ale.
  2. N

    Maggie’s stuff I have been making to pass the time.

    Nice graving.
  3. N

    Maggie’s Motivational Pic Thread v2.0 - - New Rules - See Post #1

    more like occupationalmyalgia
  4. N

    Grain weight accuracy

    with a powder trickler https://www.midsouthshooterssupply.com/item/000449089/Powder_Trickler-2_
  5. N

    OAL: How long is too long?

    Doesn't matter how long as long as the bullet bearing surface has a good purchase on the case neck. I think most people go with 1 bullet diameter into the neck as a minimum. The longer you seat it out the more powder you can fit in the case.
  6. N

    Grain weight accuracy

    You should continue to count it out until your post count climbs a bit more :rolleyes:
  7. N

    Grain weight accuracy

    that is actually pretty good for the Lee. They can take a good while to break in sometimes unlike the ones made of metal from RCBS, Redding, etc. I consider the Lee only good enough for pistol charges anyway. Keep doing whatever you're doing with it because you're doing it right. If you want...
  8. N

    1-11 twist .308 sub loads?

    my most stable load from 1:11.25 .308 is 6.0g Bullseye 175g bullet 1050fps
  9. N

    Your pets loads for 7mmRM

    65.0g is what I loaded when I used the 150s. The magic is finding the right OAL.
  10. N

    Wc 844 & 846

    Thanks for the link.
  11. N

    Wc 844 & 846

    I run 34.0-36.0g of WC844 in a 308 behind a 175g lead bullet for lower recoil plinking. It functions both AR10s just fine. You have to make your own data with these surplus powders. Lot to lot variation in burn rate does exist so each lot should be treated like a new powder. Treat the WC844...
  12. N

    Cost v. Benefit of Reloading .308

    If I could afford to buy all the ammo that I can shoot, I'd buy it too. Until then I'm handloading.
  13. N

    Powder and velocity

    cut an inch or two off the barrel. . . seriously though, forget about the velocity and find the most accurate load. When you have 'the load' you are looking for then you can make a WAG at the velocity until such time you can shoot through the chrono again. I only chrono loads after I'm finished...
  14. N

    How much is too much Jam?

    I consider an engraved length half the width of the lands to be sufficient and no added benefit with more than that, of course every bullet and rifle is different. 1/2X engraving would be about .025" for most 30 caliber barrels. but if you are by my WAG 1X approximately and it's working then...
  15. N

    Gov. Limiting Supplies?

    Of course it's a gubmint conspiracy. The big ammo makers are in bed with the enemy just like all the big airlines are in bed with the gubmint to spread mind altering chemicals from every jet that flies overhead. Yeh, so no.
  16. N

    Maggie’s Motivational Pic Thread v2.0 - - New Rules - See Post #1

    I like to see good looking women but I always remember the saying: "So guy somewhere is tired of putting up with her shit too."
  17. N

    interesting fella told me not to clean brass before reloading???

    I personally don't like to run dirty cases into expensive dies and I'm not going to wipe the dirt off one at a time. I did a 2000 round session of .45 a while back and that would have been a little eccentric. Not going to do it for 500 rounds of 308 either.
  18. N

    Too much deburring?

    Let be more thorough with my reply. After case trimming a burr is often left on the inside as well as the outside of the case mouth. There are many tools available to remedy this problem. Most common tool used by handloaders is the Cartridge Case Chamfer Tool. One of the limitations of the...
  19. N

    Stalker at my house

    My brother just bought a game camera that is supposed to be undetectable, uses blacklight LEDs or something. Don't know the make but it worked for his problem. I have a 15 camera DVR system and it is obvious so it is a deterent. Small time crooks may not notice it, but pros do notice it...
  20. N

    308 Gasgun coal.

    I load as long as the mag will allow and sort the ammo by concentricity. When the jump is long it needs to run straight before engaging the rifling. I get my best results this way. IIRC my loads run 2.815 +/-.
Top Bottom
Back
Home
Forums
Merch
Alerts