Search results

So I know I'll catch some flack for stupid questions, but I'm going to ask anyway. I just picked up this action from my FFL and it had 3 baggies stapled together and two of them had screws - the third was empty. It looks like the set screws for the QC and the trigger screws. Are these supposed...

So I have an itch to build a long range rifle. I have a Ruger PRP in 6.5CM, Savage .308, and a savage 110 in 338LM. I generally shoot 800-1200 yards. I was looking at picking up a SA 700 clone with .308 bolt to drop in a chassis. I dont compete and I prefer prone to a bench, but if I wanted to...

I havent shot this rifle in a while. I lost round count around 1500. I got the itch to shoot it but wanted to take a look at the barrel. I know it's a crap video but outside of being super dirty do you see any issues. If you have a minute to waste, I'd appreciate it.

So about 7 months ago I took advantage of the BOGO promo and ordered an 30 cal can and I'm supposed to get the octane 9 for free. Initially the ads stated that it would be four months before the free cans shipped. I was curious so I just called to see if they were any closer to getting those...

with a 50mm objective? Medium?

First, I know nothing about 22s or the scopes that are mounted to them. About the only thing I know is that the parallax needs to go down to a minimum 25 yards. I just picked up a Ruger precision rimfire because I have an RPR in 6.5CM and I need a scope. I'm looking for something budget...

This might sound stupid but I picked up a new to me scope (vortex 4.5-27) that's a bit higher quality then the other scopes I have. It's perhaps the first time I'm noticing but I can either get 1.) the crosshairs crystal clear with the target in focus but not as sharp as it could be or 2.) get...

I have a gen II Razor 4.5-27 in route. I'm putting it on a Ruger RPR in 6.5CM. I currently have a Burris XTR II 5-25 with Burris signature rings with the inserts. I'm in the market for rings and the obvious answer is Vortex/Seekins 1.45 but I dont know if they'll clear scope caps with a 56mm...

So I loaded some new Lapua brass to test in 6.5 CM. I ran them through a Redding FL bushing die to get the necks uniform. I then chamfered and deburred. When seating the bullets I noticed it took significantly more pressure to seat the bullet compared to the 50 pieces of Hornady brass I loaded...

My current load with H brass is 41.6 of IMR 4451 and it shoots well. I picked up 200 pieces of Lapua brass and I know it's about 2.Xg less capacity. Has anyone that made the switch found out about how much less power it takes to get a comparable load with switching? I know I have to test but...

I have a Ruger RPR and it has a pistol grip. It seems like I shoot regular stock, like an HS Precision, better than a chassis rifle. I'm a right handed shooter and normally I shoot with my thumb wrapped around the grip on the left (from behind the rifle). I feel like I'm either gripping too...

So I had this happen today on 3x fired Hornady brass and it's unsettling. Most of my rifle reloading has been for .308 where I used standard dies RCBS dies. I never turned necks, used an expander ball, and FL sized only bumping the shoulder back .002. I had 500 pieces of LC LR brass that was...