I used Brownells Moly/Teflon Gunkote.
The action/barrel are Dark Park Gray, the bolt is black. It turned out to my liking.
I do not know how well it is going to hold up on the stainless Broughton barrel. Even after I blasted the barrel with 80 grit aluminum oxide it was still quite slick.
That Broughton steel is hard.
I also changed to high rings from mediums to get my head in a more upright position for a more consistant cheek weld (I hope).
Check out the new bolt knob design, it rules.
All machining compliments of W.L. Daily Precision.
Action blueprinted, bolt knob, barrel cut, threaded and chambered with match reamer, PTG standard thickness recoil lug, barrel finished 20" from front of recoil lug.
I tuned the factory old style trigger myself, it breaks at 2.3lbs, added a Gre-tan lightweight firing pin and bedded the scope base with devcon.
It is a hammer...
The action/barrel are Dark Park Gray, the bolt is black. It turned out to my liking.
I do not know how well it is going to hold up on the stainless Broughton barrel. Even after I blasted the barrel with 80 grit aluminum oxide it was still quite slick.
That Broughton steel is hard.
I also changed to high rings from mediums to get my head in a more upright position for a more consistant cheek weld (I hope).
Check out the new bolt knob design, it rules.
All machining compliments of W.L. Daily Precision.
Action blueprinted, bolt knob, barrel cut, threaded and chambered with match reamer, PTG standard thickness recoil lug, barrel finished 20" from front of recoil lug.
I tuned the factory old style trigger myself, it breaks at 2.3lbs, added a Gre-tan lightweight firing pin and bedded the scope base with devcon.
It is a hammer...
