Accuracy issues after trigger job

[HDrusty]

I was shooting sub moa groups with my 700 varmint .308 until I had the trigger done. Now it's 2-3" groups at 100 and 6-9" at 200. Scope does not seem to be loose. Any ideas on that could have happened?

 

[gimpy]

I would venture to guess that the action isn't torqued back in correctly.

 

[HDrusty]

Would there be anything obvious if this were the case? When I pull and tug on everything it all seems tight.

 

[Snoball]

Take the screws out and then run them back in but not tight. Use a calibrated wrench and torque to correct INCH lbs for your stock. HS precision is 65in-lbs, and Remington recommends 35in-lbs IIRC. Did you just adjust a factory trigger or install a new one? You want to ensure the stock is not rubbing on the new trigger.