ACIS / Timney trigger

[bob6117]

I just put a Timney trigger on a Rem. 700 LA, the trigger feels great but is hitting somewhere in the stock.
The stock is a ACIS and with the barreled action in I cannot move the safety.
I'm just wondering if anyone else has had the same problem, and where I might have to inlet the stock.
Any help would be appreciated.
Thanks
Bob

 

[Hateca]

Re: ACIS / Timney trigger

Been talked about before stock or trigger will need work. This will help you find the answer.

Search

 

[300sniper]

Re: ACIS / Timney trigger

sand/file/dremel down the pin that moves out of the side of the trigger housing when the safety is engaged. it only takes a few minutes with a file.

 

[bob6117]

Re: ACIS / Timney trigger

Will do, I appreciate the feedback.
Thanks
Bob

 

[Rancid Coolaid]

Re: ACIS / Timney trigger

I solved the problem by altering the stock, not the trigger.

I'd much rather alter the stock than the trigger, but that's just me.

A screw was too long in my Timney, material had to be removed from the aluminum bedding area to accommodate the screw (or I had to endure a 7+ pound trigger pull.)

Want a picture of my alteration?

 

[mik3]

Re: ACIS / Timney trigger

Had the same problem with mine. I brought it in to a machine shop to have the stock opened up.