Has anyone played with moving the Arken zero stop location? I know how to do the default zero stop but usually like to set stop at 2 mils below zero to allow speed drop setup. It looks like you might be able to move the location of stop. Tiny hex screws from what I can tell. Smaller than I currently have a wrench for.
Adjusting Arken Zero Stop Location
- Thread starter longrange772
- Start date
They tell you how to adjust for below-0 drop in the instructions. I always zero all my rifles at 100, so I never drop below that.
Something about going a few clicks (or however far you want to go) past 0 and then tightening the ZS screw down like normal, and then backing it off 1/8 turn, then tightening the set-screw back down.
Something about going a few clicks (or however far you want to go) past 0 and then tightening the ZS screw down like normal, and then backing it off 1/8 turn, then tightening the set-screw back down.
You can adjust the zero stop ring. You will need a .9 mm hex wrench. Can move it anywhere you want. Not advertised in manual but I emailed Arken support. Very helpful and quick response.
Oh, that's cool to know. I've never pulled the turret off to look. I just readjusted the turret while installed, and then set my zero-stops. I had no idea you can move the ZS around. That's pretty cool.
My question:
"Is it possible to move the stop location from 6 o’clock position to something like the 9 o’clock position? If so, what size wrench is needed? Any information is appreciated."
Their answer:
"You can actually it will require a 0.9mm allen wrench from what I have been told."
"Is it possible to move the stop location from 6 o’clock position to something like the 9 o’clock position? If so, what size wrench is needed? Any information is appreciated."
Their answer:
"You can actually it will require a 0.9mm allen wrench from what I have been told."
