Arc nucleus and triggertech special

[Wildfire1550]

Have a TT special installed on an ARC nucleus, when I run the bolt it resets the safety. I have not had this issue with TTs on other actions, is there a way to fix this, sucks to keep having to flick the safety off every shot. Thanks

 

[KnowNothing256]

This isn't normal. Any chance you can upload a video of the issue?

 

[Wildfire1550]

Hard to film and work the bolt, the bolt is manually pushing the safety to the on position. Took a video can’t seem to figure out how to upload it

 

[pshell]

Agree with @KnowNothing256; this isn't normal. I also have a TT Special on a Nucleus 2.0, and everything works as it should. I've e-mailed the ARC people about a magazine issue, and they responded within 45 minutes. I'd reach out to them and see what they think, or swap that trigger out with a known good trigger and see what happens—best of luck.

 

[Wildfire1550]

 

[celltech]

Something is seriously messed up there...here is a pic of mine from the back. Lots of clearance between the bolt shroud and the safety. Can you take the same pic?

 

[jb0311]

Also just chiming in to say I run a TT special on an arc nuc and don’t have this issue.

 

[jb0311]

Shoot us a couple photos like this.

 

[FredHammer]

There are two versions of the TT trigger. With and without bolt release.

 

[iceng]

Is that safety unusually tall ?

 

[4O6shootist]

Does the bolt close like shit? If it has an extra low cocking piece, could be the problem. Bolt lift looks excessive. Definitely a fitment problem.

 

[Pvt.Donut]

There are two versions of the TT trigger. With and without bolt release.

Yeah, OP make sure you have the non-bolt release version, or you removed the bolt release.

 

[KnowNothing256]

I’m wondering if the safety lever is bent inwards (to the left, assuming the video isn’t mirrored). Let’s see those pics of the rear of the bolt, from above.

 

[Skunkworx]

Is your safety lever kind of bent inwards? Never had this issue with my TT and nuke or Archimedes

 

[Wildfire1550]

Guys thanks for all the reply’s and pics, jb0311 the picture from in back reply helped. The safety got a little bent and was hitting the bolt. It was a super easy fix, I should have seen it earlier. Thanks again hide