Pulled the trigger on the new V3 and am very impressed with the scale but getting under & over throws more often then not. Any advice on trickler tube angle and type surface to set scale on?
OFG
OFG
Autotrickler V3 fine points
- Thread starter oldfatguy
- Start date
Read this thread before ordering the AutoTrickler setup. Lots of good info, but nothing about tube angle other then it is important. Going to get a piece of granite counter top for a base.
OFG
Maybe another thread then , basically slightly up ( like a degree or two) at the dispensing end and then play with the ramp down slider, once I got mine set up in Version 1 I have never messed with it again and I am normally within a kernel of target which other than for OCD reasons, is golden
I'll second the suggestion of angling the discharge end of the tube sightly upward. Seems counter-intuitive, but it works. I thinks it's because the powder fills the tube more consistently than if it's level, or pointed slightly downward.
How fast are these things throwing charges now?
I don’t need anymore accuracy than I currently get but faster would be nice and I’d certainly take faster and more accurate.
I don’t need anymore accuracy than I currently get but faster would be nice and I’d certainly take faster and more accurate.
About 10 seconds per. I recently received the Bluetooth board & V3 thrower. Both are very nice adds. I’d like to see a + .01 button for a quick spin when the trickle comes up short a kernel or two. The new thrower is definitely smoother.
