So I got my Badger AX rifle pretty much done. It feeds the AXCS and AICS single stack mags just fine but not the real AX double stack mag and I assume AW as well. I will try an AW this weekend. Badger inletted the chassis for me and they told me the have 2 different inlets AICS whether its for an AICS or AW mag but only one for the AXCS. The height was a little different between the two, .040" maybe. I remember reading somewhere on here a while back that there is a mod for the latch on an AICS to use AW mags. I am thinking this mod may work on the AX for me. The problem is the AX double feed mag won't feed the left side, which is the higher side, the right is fine. The mag sits in the the chassis at an angle, lower in the back, if I push the mag up and level it will feed just fine. I was thinking if I could make the latch taller that would work but not sure how that will affect the single stack mags. The other option I was thinking is an overtravel screw to limit the amount of force on the magazine, the spring seems pretty stiff against the mag and when you push the mag back toward the latch it comes up. Any other suggestions would be appreciated. Thanks