Gunsmithing butt pad for HS Precision 700P stock needed

[coyotesniper]

I need a butt pad for a HS Precision 700P SA stock

I bought a used stock that had a Limbsaver slip on pad and guess what. The factory pad was missing

Where can I get one or what would be the closet fit with no work needed to it, and please incude the part number if you can

THANKS for your help

 

[34SF]

Pretty sure "no work" is not going to work. It's been a while but if I remember correctly, even H&S said you had to sand one down (ie, you can't order one). They wanted me to send the stock in. You'll need a bench sander and be very careful about where the long end of the stock is at all time. More talented folks may do it by hand but that ain't me. I put Pachmeyrs on three different stocks and it isn't brain surgery but screwing up will show.

I was skeered at first and started off with a local smith who said "yeah, no problem." Turned out that translated to "I have no idea what I'm doing but I saw it on YouTube." Point is, if you farm it out, make sure they know what they're doing.

 

[powdahound76]

I bought a grind to fit, marked it out, and used a belt sander. Used a finer grit to smooth it out, and attached it. Not the finest like a high end shop, but this is a rifle to use, carry around, and I expect it to get beat up. With the krylon on the stock and some scratches on it, the recoil pad just matches in. On a fine rifle this wouldn't work, but for me on this one, works great.

PS, where are you in Iowa? I was raised in the SW corner in Page County.

 

[coyotesniper]

30 miles east of Des Moines on I80