I'm looking to replace the current gas block on my DPMS SASS. It seems to be a little over-gassed. With that being said, does anybody have any recommendations for an adjustable gas block? Something you've used and been very happy with? Thanks for any advise.
DPMS SASS Gas Block
- Thread starter PharmShooter
- Start date
Re: DPMS SASS Gas Block
their both good, if you going with extended hand guard (i.e. putting a 13 inch hans guard in one that was a 7" go with the 2nd, if you using stock hand guard or using a non-floating hand-guard or cutout guard, use the 1st.
but the 2nd uses a set of set screws if u use it its a good idea to mark the place where the set screws hit and take a drill and make a little indention for them to set in to, when you get them real hot they can slip even with red locktite
their both good, if you going with extended hand guard (i.e. putting a 13 inch hans guard in one that was a 7" go with the 2nd, if you using stock hand guard or using a non-floating hand-guard or cutout guard, use the 1st.
but the 2nd uses a set of set screws if u use it its a good idea to mark the place where the set screws hit and take a drill and make a little indention for them to set in to, when you get them real hot they can slip even with red locktite
Re: DPMS SASS Gas Block
The factory DPMS SASS barrel has a tall shoulder on it behind the gas block and as a result it requires a gas block with a higher tube hole in it than most gas blocks offer. Just be sure to consider that when switching it out.
The factory DPMS SASS barrel has a tall shoulder on it behind the gas block and as a result it requires a gas block with a higher tube hole in it than most gas blocks offer. Just be sure to consider that when switching it out.
Re: DPMS SASS Gas Block
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: JCB</div><div class="ubbcode-body">The factory DPMS SASS barrel has a tall shoulder on it behind the gas block and as a result it requires a gas block with a higher tube hole in it than most gas blocks offer. Just be sure to consider that when switching it out. </div></div>
Exactly...+1
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: JCB</div><div class="ubbcode-body">The factory DPMS SASS barrel has a tall shoulder on it behind the gas block and as a result it requires a gas block with a higher tube hole in it than most gas blocks offer. Just be sure to consider that when switching it out. </div></div>
Exactly...+1
Similar threads
