I'm having a terrible time resizing my Federal .308 brass. Its on its 4 loading from just neck sizing, but its gotten a little hard to chamber so I thought I would full length size it. Ok, so no matter where I set the die, from just touching the shellholder to as far in as it will go, it wont chamber worth a damn! It actually becomes MUCH harder to chamber after full length sizing compared to chambering a fired case that I'm starting with.
I read another thread where it was suggested to shorten the shellholder to improve camming. Well, heres the kicker...no matter where I set the die or how hard I pull, the shellholder will never touch the bottom of the die!
Help!
I read another thread where it was suggested to shorten the shellholder to improve camming. Well, heres the kicker...no matter where I set the die or how hard I pull, the shellholder will never touch the bottom of the die!
Help!