I have an aero upper and lower with a drop in barrel from a well respected barrel company but the feed ramps do not guide the bullet into the chamber. I have taken this gun to two local gunsmiths and sent the rifle to the barrel maker. The barrel company did add a bevel to the face of the barrel but the bullet tip still smashes into the face of the barrel and the feed ramps barely guide the bullet at all.
barrel is chambered in a 6.5 creedmoor and I have tried 143 eld-x and 140 hybrid bullets.
Any recommendations on a gunsmith I could send the barrel to for changing of the feed ramps?
the pictures attached are before the barrel company “chamfered” the chamber entry but the bullet still impacts the face of the barrel without much of any guiding from the feed ramps.
or do I just have to chuck this up to a lost cause and buy a different barrel?
barrel is chambered in a 6.5 creedmoor and I have tried 143 eld-x and 140 hybrid bullets.
Any recommendations on a gunsmith I could send the barrel to for changing of the feed ramps?
the pictures attached are before the barrel company “chamfered” the chamber entry but the bullet still impacts the face of the barrel without much of any guiding from the feed ramps.
or do I just have to chuck this up to a lost cause and buy a different barrel?