Well im about to order my first stock( manners) and am stuck with some decisions. Ive only shot factory remmingtons stocks, specificly cheap varmint models.
The stock will be a target gun mostly from a bench but I hope to get into fclass.
Ive pretty much decided on getting an adjustable check model due to the fact its not that much more than if i were to put a karstens on it later.
I have never had the adjustable length of pull before. I honestly have no idea if i would benifet from it and the 90 bucks it will cost me. Any opinions?
Now the bigger question is where should i put the flush cups? Again i have never had studs other than the 3 that came from the factory let alone flush cups. The rifle will have an atlas rail on the front that will supply one flush cup. i was thinking about putting one on the bottom rear 1 on the left rear and one on the front left(will be a Right hand rifle)
anybody that could help me or feed me bullshit on the subject will be thanked lol..
The stock will be a target gun mostly from a bench but I hope to get into fclass.
Ive pretty much decided on getting an adjustable check model due to the fact its not that much more than if i were to put a karstens on it later.
I have never had the adjustable length of pull before. I honestly have no idea if i would benifet from it and the 90 bucks it will cost me. Any opinions?
Now the bigger question is where should i put the flush cups? Again i have never had studs other than the 3 that came from the factory let alone flush cups. The rifle will have an atlas rail on the front that will supply one flush cup. i was thinking about putting one on the bottom rear 1 on the left rear and one on the front left(will be a Right hand rifle)
anybody that could help me or feed me bullshit on the subject will be thanked lol..