Gas block question

[drglock]

I’ve got a Noveske 16” with a mid gas system with a standard gas block I’d like to swap out for an adjustable block. My gas block is the standard low Noveske that’s pinned to the barrel. Can I just use an adjustable gas block that is the clamp on style since I don’t see a lot of options for pinned blocks.

 

[msgriff]

Does your existing GB have the single roll pin centered at the bottom of the block? If so, Noveske has a Superlative AGB with set screws and the pin. Otherwise, a clamp-on will work as long as it fits under the handguard.

 

[drglock]

Does your existing GB have the single roll pin centered at the bottom of the block? If so, Noveske has a Superlative AGB with set screws and the pin. Otherwise, a clamp-on will work as long as it fits under the handguard.

Yes it has the single roll pin

 

[msgriff]

Yes it has the single roll pin

Also, the single pin in the center should not interfere with the set screw locations on the barrel, if you wanted to go that direction. Then you get into the dimple debate.

 

[drglock]

Also, the single pin in the center should not interfere with the set screw locations on the barrel, if you wanted to go that direction. Then you get into the dimple debate.

Thanks