GGP profile question

[Yippeekiay]

So I bought a GGP billet for an ar10 (other) build and have a question about high/low profile hand guards. Generally the tab over the charging handle indicates high/low by being 3/16" or 1/8" respectively. The tab on my receiver is almost 1/4".
Am I going to have trouble finding a hand guard that transitions flat without buying and trying a bunch or is there something I'm missing?
For what its worth, I'm eyeballing this one because I like the barrel nut design..

SMF Tactical Mil Spec 80 Percent Lower Receivers, 20 in. Hand Guards, 30-06, 300 WinMag, Creedmoor

SMF Tactical Manufacture of Mil Spec AR Parts, Hand Guards,9mm Lower Receivers

www.smftactical.com

Advice please..
Thanks

 

[msgriff]

This might help.

Profile dimensions - centerline of bore to top of rail:
AR-15 - 1.215"
DPMS low - 1.253"
DPMS high - 1.313"
DPMS Target - 1.638"
ArmaLite AR-10 - 1.315"

DPMS G2 is the same as a AR-15

 

[Yippeekiay]

A good start..
Thank you, Sir

 

[msgriff]

A good start..
Thank you, Sir

No problem. Grey Ghost says that its uppers are DPMS high. Make sure and measure the tang at the center, the outside edges are usually thicker.

 

[J-Fonz]

GG is DPMS high.