http://www.ar15.com/forums/topic.html?b=6&f=42&t=311884
Just a darn good idea, Kudos to the original "inventor" !
Just a darn good idea, Kudos to the original "inventor" !
Gotta share this one....For XL650 Owners
- Thread starter bfoosh006
- Start date
Re: Gotta share this one....For XL650 Owners
Not a bad idea, I too had the same problem of powder being knocked out. Too bad I sold my xl650.
Not a bad idea, I too had the same problem of powder being knocked out. Too bad I sold my xl650.
Re: Gotta share this one....For XL650 Owners
Just bought one last week and had the same damn problem, was so pissed off I almost tried to sell the machine, i tried the detent spring trimming and it worked flawlessly, this was the back up plan. You may try to trim a full coil off the shell plate detent spring first as I had good luck with it.
-Taylor
Just bought one last week and had the same damn problem, was so pissed off I almost tried to sell the machine, i tried the detent spring trimming and it worked flawlessly, this was the back up plan. You may try to trim a full coil off the shell plate detent spring first as I had good luck with it.
-Taylor
Re: Gotta share this one....For XL650 Owners
I bought one of these about a year ago. Works great. UniqueTek sells a kit for the 550 that includes the bearing and a machined indexer. I asked about buying just a bearing and was told it wouldn't work with a 650. I'm glad I didn't take them at their word.
I bought one of these about a year ago. Works great. UniqueTek sells a kit for the 550 that includes the bearing and a machined indexer. I asked about buying just a bearing and was told it wouldn't work with a 650. I'm glad I didn't take them at their word.
Re: Gotta share this one....For XL650 Owners
Just ordered me a set and a set for a buddy that has a 650. I think he will like the gift!
Just ordered me a set and a set for a buddy that has a 650. I think he will like the gift!
Re: Gotta share this one....For XL650 Owners
http://www.snipershide.com/forum/ubbthre...rue#Post1017163
Some good Info on this page also.
Beware I bought some of these knobs and they didn't fit. I'll double check my numbers but the knobs I got were to big.
http://www.snipershide.com/forum/ubbthre...rue#Post1017163
Some good Info on this page also.
Beware I bought some of these knobs and they didn't fit. I'll double check my numbers but the knobs I got were to big.
Re: Gotta share this one....For XL650 Owners
Picked Up the bearings and Washers from Purvis Industries today
Bearing Part # NTA815 $2.15 each
Washer Part # TRA815 $.81 each
Picked Up the bearings and Washers from Purvis Industries today
Bearing Part # NTA815 $2.15 each
Washer Part # TRA815 $.81 each
Re: Gotta share this one....For XL650 Owners
I've never had a problem with my 650, I just put the bullet in as soon as the shell comes down from the powder die and hold it in in place until it goes into the seating die.
I've never had a problem with my 650, I just put the bullet in as soon as the shell comes down from the powder die and hold it in in place until it goes into the seating die.
Similar threads
