Gunsmithing Help on this 300 win mag project...

[michael sr.]

I have a stainless m70, CRF, 300 win mag 26".

I'd like to make it a bit more 'compact' if you'll allow that term. I am thinking 20, 21, 22 inch barrel vs the current 26". Kinda thinking it might be much nicer to tote around in Alaska; also have the same model in 338 WinMag and a ton of ammo for both!

Ruger has a similar rifle in a stainless guide series but krud it is IMPOSSIBLE to locate a retailer who has one !!!

if I go with the 300, I'd be able to use my suppressor, lower 48...

Your thoughts....are valued!!!

Mike sr.

 

[yellowXJ]

The question ultimately comes down to whether or not you want to maintain the velocity that is typical from a 300WM. I would personally not want to cut it down shorter than 22". At that point, you may as well have a shorter barelled gun in a different caliber.

 

[michael sr.]

Hand loads: 220 grain, 2400-2550, depending on powder used, not looking max vel...just for best, consistent accuracy.

22" prolly good to go!