I installed some folding Noveske iron sites on my Noveske 5.56 and went to the range to site them in. I ended up having to crank the rear windage site almost all the way over to the right side to get on target. It looks kind of odd being that far over. Is this normal, or is there some other way that would leave the rear site more centered (like a shim between the rail and one side of the site?
Iron site issue.
- Thread starter greydarrah
- Start date
Re: Iron site issue.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: red6actual</div><div class="ubbcode-body">Do you have a standard front sight base/post?
</div></div>
The rifle is a flat top and both the front and rear irons are Noveske folding sites (made by Troy Industries), both attached to the rail.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: red6actual</div><div class="ubbcode-body">Do you have a standard front sight base/post?
</div></div>
The rifle is a flat top and both the front and rear irons are Noveske folding sites (made by Troy Industries), both attached to the rail.
Re: Iron site issue.
I have a Noveske Low-pro and the sites seem to be somewhere in the midle with plenty of room to elevate. I would call them to get their take on the situation.
I have a Noveske Low-pro and the sites seem to be somewhere in the midle with plenty of room to elevate. I would call them to get their take on the situation.
Re: Iron site issue.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: m14er</div><div class="ubbcode-body">I have a Noveske Low-pro and the sites seem to be somewhere in the midle with plenty of room to elevate. I would call them to get their take on the situation. </div></div>
I can give them a call Monday, but it was the rear site that I've had to crank all the way over. The front post was almost dead on elevation, right out of the box.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: m14er</div><div class="ubbcode-body">I have a Noveske Low-pro and the sites seem to be somewhere in the midle with plenty of room to elevate. I would call them to get their take on the situation. </div></div>
I can give them a call Monday, but it was the rear site that I've had to crank all the way over. The front post was almost dead on elevation, right out of the box.
Re: Iron site issue.
Got to be an issue with the sighs then, if you had a FSB then it might be canted but not the case.
Got to be an issue with the sighs then, if you had a FSB then it might be canted but not the case.
Similar threads
