Kestrel Batteries
- Thread starter pmclaine
- Start date
I’ve been using mine twice a week or more since I got it.
Battery levels were all over for a while but now they’re pretty stable now and pretty high.
Battery levels were all over for a while but now they’re pretty stable now and pretty high.
Go to memory settings
Take Auto-Store off.
It is the default setting.
If it is already off...
Lithium batteries stay at 3.7V for long time unlike alkalis. Thus without calibration file of some sort to monitor its power consumption, you have just a guess.
Most likely it will show charge between 20-100% which is mostly temperature linked.
I still have not replaced batteries on mine but I carry a spare just as any other device I have.
Take Auto-Store off.
It is the default setting.
If it is already off...
Lithium batteries stay at 3.7V for long time unlike alkalis. Thus without calibration file of some sort to monitor its power consumption, you have just a guess.
Most likely it will show charge between 20-100% which is mostly temperature linked.
I still have not replaced batteries on mine but I carry a spare just as any other device I have.
Last edited:
Good info.
Mine is acting in the same manner as everyone else.
Lithium battery is installed. Pretty sure Auto store is already off.
Confident now I wont have to worry it will go TU in the middle of my class tomorrow.
Mine is acting in the same manner as everyone else.
Lithium battery is installed. Pretty sure Auto store is already off.
Confident now I wont have to worry it will go TU in the middle of my class tomorrow.
If mine is going to to sit for a bit, I take the batteries out.
I had the same problem with a (~6 years-old) 4500.
It was eating batteries like a short-circuit, until the day I found an option somewhere in the device's settings to specify the type of batteries -- Li, NiCd, etc.
Check it out; specifying the right type of power source did make a huge difference for me.
It was eating batteries like a short-circuit, until the day I found an option somewhere in the device's settings to specify the type of batteries -- Li, NiCd, etc.
Check it out; specifying the right type of power source did make a huge difference for me.
Yep Im on Li.
Just a flukey display. Will show one capacity to start but than "warms" up and gives a better solid reading.
Similar threads
