When Remington, Winchester etc...... manufacturer a particular chambering are they all consistent with the same dimensions , like head space etc..... ?
- Thread starter WhiteOak
- Start date
Not from my experience.
No where near close to consistent
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Manufacturers and chamberings
There's a spec, and they will all be to that spec within a tolerance. That means barrel A may not be cut exactly the same as barrel B, but it's close enough that factory ammo can safely be fired in each.
There's a spec, and they will all be to that spec within a tolerance. That means barrel A may not be cut exactly the same as barrel B, but it's close enough that factory ammo can safely be fired in each.
Last edited:
One of the reasons to hand load.
I would like to do that one day.
I would like to do that one day.
Google SAAMI
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
