McMillan A-4/saddle cp slips.

[Tflhnd1]

I have a Mac A-4, (USMC RETURN HAHAAHAHAHAHAAHA), that I use on my work gun and I like it very much. However it HAS been around the block a bit and regardless of how hard I crank the tension screws down, they give way sometimes when the shot breaks.

I pulled the cp out and noticed the aluminum post that is stipled for the tension screws is worn quite a bit. Is there a better system or a mod to do to make it lock better or do I send it Mac.

I've seen operational M40A3's with big pads taped on instead. I don't want to go that route if I don't have to. Just looking to see what the options are. Thanks for any responses. Jeff.

 

[WRENCHHEAD]

Re: McMillan A-4/saddle cp slips.

what you can do is get 2 plug/set screws and thread them into the other side and tighten them down. that way it will have 4 points of contact. i think the size was 10-32 X 3/4 inch long

 

[AXEMAN]

Re: McMillan A-4/saddle cp slips.

or you can do like da-law-dawg did in his DIY

BAM!!

http://www.snipershide.com/forum/ubbthreads.php?ubb=showflat&Number=2598715#Post2598715

 

[Ackley Improved]

Re: McMillan A-4/saddle cp slips.

Or get rid of the stock.... preferably to me!!!

 

[MAGUA]

Re: McMillan A-4/saddle cp slips.

How much do you want for that old worn out piece of crap

 

[grunt0311]

Re: McMillan A-4/saddle cp slips.

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Tflhnd1</div><div class="ubbcode-body">I have a Mac A-4, (USMC RETURN HAHAAHAHAHAHAAHA), that I use on my work gun and I like it very much. However it HAS been around the block a bit and regardless of how hard I crank the tension screws down, they give way sometimes when the shot breaks.

</div></div>

Ill trade you mine and you wont have a problem with it!