Gunsmithing Need help ID'ing bottom metal inlet

[JCH]

If anyone can shed any light on this I would appreciate it.

Bought this stock and was under the assumption that it was BDL bottom metal for a R700. I put BDL bottom metal on and this is the gaps I can see.

Any help is appreciated.

 

[BOLTRIPPER]

Re: Need help ID'ing bottom metal inlet

man.....i don't know what to say......maybe badger ??

 

[JCH]

Re: Need help ID'ing bottom metal inlet

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: BOLTRIPPER</div><div class="ubbcode-body">man.....i don't know what to say......maybe badger ??</div></div>

I was thinking that. I know it is hard to tell with a pic.

 

[Kells81]

Re: Need help ID'ing bottom metal inlet

How about a DD Ross metal? Could be a Badger M4 but I do not think the front area looks right for that.

 

[Kells81]

Re: Need help ID'ing bottom metal inlet

better pics,

Check this out

 

[JCH]

Re: Need help ID'ing bottom metal inlet

that looks pretty close Poke. I just hate the thought of buying bottom metal to fit it and it not fitting.

 

[Kells81]

Re: Need help ID'ing bottom metal inlet

Know anyone close with a Badger M4 or M5 setup

 

[HarryCallahan]

Re: Need help ID'ing bottom metal inlet

Looks like a Williams

 

[Kells81]

Re: Need help ID'ing bottom metal inlet

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Harry Callahan</div><div class="ubbcode-body">Looks like a Williams </div></div>

Here is a Pic of a Williams and PTG which both are near drop in's to the regular BDL FP. The PT&G is a Direct and the williams needs some loving back by the TG. Definately not a williams...

And a Pic of a Badger M4 Short,

 

[JCH]

Re: Need help ID'ing bottom metal inlet

I might ask a few guys I know to look at it. Most of them have the surgeon DBM.

I really think it is one of the DBM inlets like Badger, CDI, Seekins or something. The person I bought it from is absolutely no help. My initial PM to him is unanswered after four hours (despite reading it) so I am thinking he isn't going to help me much.

 

[burneyr]

Re: Need help ID'ing bottom metal inlet

JCH,

I don't know if these will help, but I pulled a couple rifles out and snapped this pic.

D.D. Ross on the left rifle and Williams on the right rifle

 

[HarryCallahan]

Re: Need help ID'ing bottom metal inlet


<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Poke</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Harry Callahan</div><div class="ubbcode-body">Looks like a Williams </div></div>


Here is a Pic of a Williams and PTG which both are near drop in's to the regular BDL FP.
The PT&G is a Direct and the williams needs some loving back by the TG. Definately not a williams...

</div></div>
I should have been more specific, a Williams pushbutton style.

Badger and DD Ross BM inlet is too deep for his R700 BM to work without a stack of spacers, the Williams is shallower.

Pics of a 700 BM in a Williams pushbutton inlet -