I ordered a large quantity of the Sierra 155 Palma bullets. I'm using CCI-BR2 primers, and either LC77 cases, LC75M, or Federal GMM brass. All the brass is prepped the same. Flash holes deburred, primer pockets uniformed, brass all trimmed to same length, deburred outside, and inside with a VLD reamer.
Velocities between the 3 different cases is within 20fps with the same load I had been using: 168 Nosler competition, Reloader 15 powder.
I'll be primarily shooting the ammo out of a Sako TRG22, but will also shoot this ammo in a DPMS LR308 with 24 inch tube, and a FNAR with 20 inch heavy fluted barrel. Although it would be great if the load would shoot in all the rifles, I really want it to perform best in the Sako.
My load of 168 grain bullet and Reloader 15 gave inch groups in all rifles, better in some...
So, if anyone has suggestions for a good load using 155 Sierra Palma bullets (2156 I think), Varget, and CCI-BR2 primers, I would really appreciate it.
I'm an accuracy over velocity guy if that makes any difference. All the velocity in the world doesn't do a damn bit of good if I don't hit what I'm aiming at.
Velocities between the 3 different cases is within 20fps with the same load I had been using: 168 Nosler competition, Reloader 15 powder.
I'll be primarily shooting the ammo out of a Sako TRG22, but will also shoot this ammo in a DPMS LR308 with 24 inch tube, and a FNAR with 20 inch heavy fluted barrel. Although it would be great if the load would shoot in all the rifles, I really want it to perform best in the Sako.
My load of 168 grain bullet and Reloader 15 gave inch groups in all rifles, better in some...
So, if anyone has suggestions for a good load using 155 Sierra Palma bullets (2156 I think), Varget, and CCI-BR2 primers, I would really appreciate it.
I'm an accuracy over velocity guy if that makes any difference. All the velocity in the world doesn't do a damn bit of good if I don't hit what I'm aiming at.