Just got one in and got my T4A back from Manners with the new inlet job. I put the barreled action in the stock and tightened the actions screws and when I tried to seat the mag it stops solid before it catches. I looked in from the bottom of the mag well and I can see about and 1/8" of the action hanging over the front edge of the bottom metal and a "nub" hanging over the back edge. Does the bottom of the action have to be cut or "opened up" to make these dbms work? Is this typical? I didn't have any install instructions and I tried to call Seekins before they left today with no luck. The reason I'm asking is because it's supposed to go to the gunsmith in the morning.
Thanks,
Heat
Thanks,
Heat