New Member and Tube gun build

[Geddy]

Hello from Colorado. Here is my Eliseo tube gun that I just finished up.
Eliseo RTS chassis
Brux 26" fluted barrel 1 in 8.5 twist chambered in 6.5mm CM
Remington 700 SA
Eliseo HD bipod
Nightforce 5.5-22x56mm MOAR reticle MOA

So far, it shoots the 140gr Amax factory loads just fine

 

[pappy42]

I enjoyed the photos of your build including the target. I'm having a RTM built configured like your RTS. Did you shoot that target off of the bipod?

Any comments about the rifles "feel", ergonomics, ect would be appreciated.

 

[colscar]

nice rifle. whats the wight on that?

 

[SAPenguin]

Hi Geddy! I have always wanted to see an Eliseo tube gun - heard nothing but good things about them!
PS - if you are able to, there should be a match this saturday at CRC. Come on down if you can!

 

[Geddy]

I haven't weight it yet. Feels around 12-14 pounds to me. The group was shot off of the bipod, sand bad for rear support. This is how it performed today at 200 yards using the same factory ammo. I am very pleased with this build so far.

 

[Geddy]

I enjoyed the photos of your build including the target. I'm having a RTM built configured like your RTS. Did you shoot that target off of the bipod?

Any comments about the rifles "feel", ergonomics, ect would be appreciated.

I have never had the ability to adjust a chassis system like this. It has better ergonomics than a AR platform plus the accuracy of a bolt gun. Eliseo did a fine job on this.

 

[Geddy]

nice rifle. whats the wight on that?

The whole set up weighs 15.5 pounds