Hi, I'm in the middle of bedding my Remington 700 SPS to a Bell & Carlson Medalist Tactical stock. When I set the barreled action into the stock The tang is raised slightly (1/8"). When I push down on to the tang as if tightening it down, the end of the barrel raises. My question is should I wrap enough tape at the end of the barrel to where it makes the Tang sit flush to begin with? It appears that the metal bedding area behind the recoil lug is the area causing the action/Tang to rock. That area had 100% wear marks from the barrel. Should I try to take out some of that aluminum bedding or just put tape on the end of the barrel and in front of the recoil lug to where it makes the Tang sit flush? Also should I put bedding material at the Tang as well? I was mainly bedding it because the recoil lug area has way to much play. Thanks for any help. This is my first bedding attempt.