100 Lapua cases fully prepped and neck turned. All have been reloaded 8 times. Except for early load development all have had the same treatments including sizing, trimming, etc. Neck sized after initial fire forming. Bullet used is 168gr SMK.
However about 6 of these cases no longer hold the bullet with any tension. They will actually allow the bullet to be pushed down with finger pressure after seating. The others hold just fine.
Should I anneal these cases or all of the batch or is there another problem?
However about 6 of these cases no longer hold the bullet with any tension. They will actually allow the bullet to be pushed down with finger pressure after seating. The others hold just fine.
Should I anneal these cases or all of the batch or is there another problem?